Step 1) Unscrew battery compartment cap anti-clockwise and unfold battery connection leads to their extent.
Step 2) Attach batteries to clips and place into battery cap, fold leads into unit and screw cap and batteries into the units main body in a clockwise direction.
Step 3) The unit is now ready to activate. Use any model Modiewark non contact voltage detector and set it to the highest value that can be set.
NOTE: The tester is best tested on the maximum range of the Modiewark, if only one test is to be completed.
Step 4) Holding the Modiewark tester in one hand and the Modielive testing unit in the other hand. Face the two units towards each other making sure the LIVE AREA is facing the Modiewark non contact voltage tester.
Step 5) Depress the testing units on switch for two or three seconds. The non contact voltage detector will indicate a voltage.
When on the 500 KV setting on the non contact 4344 or 4644 tester, the distance range between the to testers is 30 mm to 60 mm. As you decrease the voltage range on the Modiewark tester, the distance between the two testers will be further apart.
Step 6) If required Step 3 to step 5 can be repeated using every voltage on any of the Salisbury non contact voltage detectors .
Please Note: The lower the voltage setting on the Modiewark non-contact voltage detector the further away the signal will be detected.
The test procedure should be carried out when holding in the hands.
It is not recommended that the batteries be left in the unit over long periods of time.